Experience your washing miracle with soap: this is how you lather your beard properly!
With plenty of nice feedback, we get feedback that the beards of new and old customers are soft and fluffy thanks to our beard soap. And yet we often get the same question - how is the body and beard soap Clean by GØLD's applied correctly and above all most effectively?
The watering
Wash your beard thoroughly with warm water in the shower. Once with the shower head over it, brings nothing. The hair must be soaking wet. You feel the hair change as you run your hand through the beard. Only then is it time for the next step.
The soaping
Take your bar of soap and rub it over your beard with light pressure. Always back and forth, in small circular movements. Don't forget the mustache and the sideburns! Then you put the soap aside. You don't need more of that today. Important: Only soap up once per shower, otherwise you will remove too much natural skin fat. It is enough if you use the soap 2-3 times a week.
The lathering
Now tender manual work is required. Rub your beard with your palms! The dampness of the beard hair and the pure soap abrasion on the beard hair creates a nice, firm foam very quickly. Keep lathering the soap. After about 20 seconds you will notice how the soap foam is getting firmer and more compact. Now is the point where you stop.
The impact
The clean soap cares for the beard and the underlying skin with a combination of different oils and ingredients, including argan, babassu and hemp seed oil. So that these active ingredients can develop optimally, it is important to let the foam take effect for a short time. As a rule, one to two minutes is sufficient here. But at the end of the day, everyone has to test for themselves how much time is good for their skin with each soap.
The rinse
After the exposure time, run warm water through your beard. This time you have to rinse for a long time because you want to avoid soap residue in the beard. When you feel the hair is clean, simply rinse again. Then you are on the safe side.
The aftercare
Finally, briefly dry your beard with a towel and massage in a few drops Bartol in while you're still in the shower. Then you set the shower to ice cold and rinse your beard again.
And now off to the shower, practice!
Hey Dr. ,
mich würde das auch mal interessieren wie ich nach dem Auswaschen des Bartöls vorgehen soll. Reicht durchkämmen ? Oder nach dem Trocknen , nochmal leicht einölen .
Guten Rutsch !!!!
Ok, klingt alles sinnig und klappt auch, erstmal danke für die Erklärungen zum Thema Seife. Jetzt frag ich mich aber wie das weitere Vorgehen mit dem Öl ist. Durch das kalte ausspülen, wird das Öl ja im Haar eingeschlossen. Normal Öl ich ganz nochmal nach dem waschen, föhne und Öl dann noch etwas nach. Aber nach der für mich neuen Methode würd ich ja drei mal Ölen. Ist das nicht etwas viel? Soll ich jetzt vor und nachdem föhnen kein Öl mehr nehmen? Ich bin so verwirrt, bitte um Hilfe!
Ich danke Dir für die ausführliche Beschreibung…? War von der ersten Lehrstunde schon begeistert. Nachdem ich jetzt die Aleppo Seife habe drei ich mich jetzt auf’s Bart waschen. Wünsche eine besinnliche Weihnachtszeit und einen guten Rutsch ins neue Jahr…lass Krachen ??
Leave a comment